Configuring Identification Information For Directors And Edge Switches - HP StorageWorks HA-Fabric Manager Installation Manual

Hide thumbs Also See for StorageWorks HA-Fabric Manager:

Table of Contents

Figure 57 Call Home Event Notiﬁcation Setup dialog box

Place a check mark in the Enable Call Home Event Notiﬁcation option.

This enables the call home function for the HAFM appliance, as well as for

all Directors and Edge Switches that have also been enabled for call home

notification.

Configuring identification information for directors and edge switches

This procedure describes how to configure identification information for each Director

and Edge Switch that is managed by the HAFM appliance.

Repeat this procedure for each Director or Edge Switch you want to configure for call

home event notification

NOTE:

In order for Directors and Edge Switches to be managed by the HAFM appliance,

you must first add them using the HAFM application. Refer to the

HA-Fabric Manager User Guide

Complete the following steps for each Director or Edge Switch managed using HAFM:

From the HAFM main window, double-click on the icon for the device. The

Hardware View for the device is displayed.

On the menu bar, click Conﬁgure > Identiﬁcation. The Configure

Identification dialog box is displayed

HP StorageWorks HA-Fabric Manager Appliance installation guide FW07.00.00/HAFM

for more information.

(Figure

58).

HP StorageWorks

SW 08.06.00

Table of Contents