Testing Remote Notification - HP StorageWorks HA-Fabric Manager Installation Manual

3. Place a check mark in the Enable Call Home Event Notification option.
This enables the call home function for the HAFM appliance, as well as for
all Directors and Edge Switches that have also been enabled for call home
notification.
To enable the call home feature on individual Directors and Edge Switches, perform the
following for each Director and Edge Switch:
1. From the HAFM main window, open the Element Manager for the device. The
Hardware View for the device is displayed.
Click Maintenance > Enable Call Home Notification.
2.
Place a check mark in the Enable Call Home Event Notification option.
3.
4. See

Testing remote notification

Testing remote notification
If call home notification features are enabled, set up the HAFM application to test
these remote notification features. Because the features are configured at the HAFM
application, call home event notification is enabled for multiple Directors and Edge
Switches.
NOTE:
Prior to testing remote notification, complete the steps in the previous sections:
• Configure the call home via Dial-Out Feature
• Configure Proactive Services Call Home via LAN Feature
To test remote notification:
1. Enable call home event notification through the HAFM appliance.
a. Click Monitor > Event Notification > Call Home.... The Call Home
Event Notification Setup dialog box is displayed
• If a check mark is displayed in the check box, call home is enabled.
• If a check mark does not display in the check box, click the box to
2. Click Send Test. A call home test message is transmitted and an Information
dialog box is displayed.
Click OK.
3.
66
Configuration
add a check mark.
for instructions on testing the call home feature.
(Figure 57).