Configuring Call Home Via Lan On The Hafm Appliance; Enabling Call Home Via Lan - HP StorageWorks HA-Fabric Manager Installation Manual

Hide thumbs Also See for StorageWorks HA-Fabric Manager:

Table of Contents

SANworks Management appliance or other server running the HP Proactive Services

software.

NOTE:

To order Proactive Services software, contact your HP customer service representative.

Configuring call home via LAN on the HAFM appliance

Use these steps to configure call home on the HAFM appliance.

Verify that the HAFM appliance is connected to a LAN with access to the

server running the HP Proactive Services software.

Locate the hp-lan.properties file in the following location:

<install_home>\CallHome\Config

Following is an example of file contents:

CSGIpAddress=localhost

Using any ASCII text editor, make the following changes to the hp-lan.properties

file:

CSGIpAddress — Delete localhost and enter the IP address of the HP

Services Gateway in appropriate format (xxx.xxx.xxx.xxx).

If you have changed the contents of the hp.lan.properties file, reboot the

HAFM appliance.

The HAFM appliance is now configured to automatically call home through the LAN

connection to a service support facility to report Director, Edge Switch, or HAFM

appliance problems.

You must now enable the call home feature on the HAFM appliance itself as well as

each Director and Edge Switch through the HAFM application on the HAFM appliance.

To enable the call home feature on the HAFM appliance:

displayed

Click Monitor > Event Notiﬁcation > Call Home.... The Call Home

Event Notification Setup dialog box is displayed

HP StorageWorks HA-Fabric Manager Appliance installation guide FW07.00.00/HAFM

Logging into

(Figure

56).

HAFM. The HAFM main window is

(Figure

57).

SW 08.06.00

Table of Contents