Configuration; Configuring Hafm Appliance Password And Network Addresses; Configuring Lcd Panel Password - HP StorageWorks HA-Fabric Manager Installation Manual

3 Configuration
Configuring HAFM appliance password and
network addresses
Verify the type of LAN installation with the customer's network administrator. If the
HAFM appliance or equipment cabinet is installed on a dedicated LAN, network
information does not require change. Change the default password for the appliance's
LCD panel (if required by the customer), then go to
appliance
If the HAFM appliance is installed on a public LAN segment, change the default
password for the HAFM appliance's LCD panel and the following transmission control
protocol/internet protocol (TCP/IP) network information to conform to the customer's
LAN addressing scheme:
• IP address.
• Subnet mask.
NOTE:
At some customer installations, TCP/IP addresses for the HAFM appliance may be
allocated automatically using dynamic host configuration protocol (DHCP).

Configuring LCD panel password

To configure a new LCD panel password at the HAFM appliance:
1. At the LCD panel, press ENTER. The Welcome!! or operational information
message changes to the following
HP StorageWorks HA-Fabric Manager Appliance installation guide FW07.00.00/HAFM
information.
Configuring additional HAFM
(Figure 13):
SW 08.06.00
31