Table of Contents
Advertisement
Configuring LAN Information for the MP
This section describes how to set and verify the server MP LAN port information. LAN information includes
the MP network name, the MP IP address, the subnet mask, and gateway address. This information is
provided by the customer.
To set the MP LAN IP address:
Step 1. At the MP Main Menu prompt (MP>), enter cm. to enter the MP Command Menu.
Step 2. From the MP Command Menu prompt (MP:CM>), enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. Write down the
information or log it to a file, as it may be required for future troubleshooting. See Figure 4-8.
NOTE
Figure 4-8The lc Command Screen
NOTE
Step 3. At the prompt, Do you want to modify the configuration for the customer LAN?, enter y
The current IP address is shown; and the following prompt displays: Do you want to modify it?
(Y/[N])
Step 4. Enter y.
Step 5. Enter the new IP address.
The customer must provide this address for network interface 0.
Chapter 4
If the Command Menu is not shown, enter q to return to the MP Main Menu, then
enter cm..
The value in the "IP address" field has been set at the factory. Obtain the actual LAN
IP address from the customer.
Cabling and Power Up
Configuring LAN Information for the MP
55
Advertisement
Table of Contents
