Connecting Serial Devices - National Instruments ENET-232 Series User Manual

Connecting Serial Devices

1 Serial Ports 1 and 2
© National Instruments Corporation
Connect your serial devices at this time. Connect one end of the serial cable
to one of the serial port connections on the rear panel of your serial device
server. Connect the other end of the serial cable to your serial device.
Figure 5-3 shows the location of the serial ports on a four-port serial device
server.
1
Figure 5-3. Location of Serial Ports on a Four-Port Serial Device Server
Refer to Appendix D,
cabling specifications.
2
2 Serial Ports 3 and 4 (on four-port models only)
Serial Port Information, for more information about
5-3 ENET-232 and ENET-485 Series User Manual
Chapter 5 Verify the Installation