Table of Contents
Advertisement
Index
general port settings
COM port number, 4-5
FIFO settings, 4-5
transceiver mode, 4-5
general programming requirements, 6-1
getting started, 1-2
H
half duplex, D-4
half-duplex system (figure), D-4
hardware problems
cannot open port, C-4
cannot send/receive data, C-4
Ethernet LEDs flash in unison, C-4
PWR/RDY LED continues to flash, C-4
PWR/RDY LED is red, C-4
scrambled data, C-4
unit does not power on, C-3
help
technical support, F-1
hostname
accepting DNS hostname, 3-8
changing DNS entry, 3-8
default hostname, 2-2
determining, 6-5
determining hostname for any IP address,
C-2
editing, 3-8
problem accessing device, C-2
registered with DNS, C-2
resolving verification error, 3-8
using to add new serial interface, 4-2
using to identify device, 6-3
verifying, 3-7
viewing or changing, 3-4
humidity
operating and storage, E-1
ENET-232 and ENET-485 Series User Manual
I
installation
getting started, 1-2
verification, 5-1
Linux x86/Solaris 2.x, 5-2
Windows 2000/NT 4.0, 5-1
installing
bias resistors on ENET-485, 6-12
serial device server, 2-2
serial server software, 2-1
terminating resistors, D-5
IP address
acquiring automatically using DHCP, 2-4
assigning manually, 3-2
choosing a static IP address, 3-6
defined, 3-6
determining, 6-5
static IP address, 6-3
using to add new serial interface, 4-2
IP address assignment
if error message, 2-5
if failed, 2-5
if not successful, 2-5
if successful, 2-4
IP parameters
DNS server, 3-6
gateway IP, 3-6
if assigned by network administrator, 3-6
if assigned by user, 3-6
IP address, 3-6
static IP parameters, 3-6
subnet mask, 3-6
ipconfig
viewing network settings, C-3
K
kit contents, 1-2
Index-4
ni.com
Advertisement
Table of Contents
