Table of Contents
Advertisement
Serial Port Configuration
Adding a New Serial Interface
Windows 2000/NT 4.0
© National Instruments Corporation
This chapter describes how to configure your computer to use the serial
device server.
The Serial Configuration utility is fully integrated into the
Windows 2000/NT Control Panel. Use this utility to add a new serial
interface.
1.
Select Start»Settings»Control Panel»NI Ports to launch the Serial
Configuration utility.
2.
Select a new interface from the Add a New Serial Interface
pull-down listbox and click Add.
Figure 4-1. Adding a New Serial Interface
4-1
ENET-232 and ENET-485 Series User Manual
4
Advertisement
Table of Contents
