Table of Contents
Advertisement
Chapter 1
Introduction
LED Overview
1
1 Power/Ready LED
2 Ethernet LEDs
ENET-232 and ENET-485 Series User Manual
Dynamic Host Configuration Protocol (DHCP) is available on many
networks to configure network parameters automatically. DHCP simplifies
the installation and configuration process for the serial device server. For
more information about DHCP, refer to the section,
Chapter 6,
Using Your Serial Device
If your network does not support DHCP, use NI Ethernet device
configuration as described in Chapter 3,
configure network parameters for the serial device server.
Figure 1-1 shows the light-emitting diodes (LEDs) on the ENET-232/4
serial device server. The LEDs are visible from the top and front of the unit.
2
Figure 1-1. Front Panel of a Four-Port Serial Device Server
Server.
Ethernet
3
3 Serial Port LEDs
4 Power Switch
1-4
Using
DHCP, in
Configuration, to
4
ni.com
Advertisement
Table of Contents
