Step 3. Connect The Cables - National Instruments ENET-232 Series User Manual

1 Serial Number

Step 3. Connect the Cables

2
1 Configuration Reset Switch
2 Power Connection
3 Ethernet Connection
© National Instruments Corporation
2 Ethernet Address
Figure 2-1. Serial Device Server Baseplate Identification Label
You can change the hostname after you finish the installation and
configuration steps in this chapter. Refer to the
Settings section in Chapter 3,
information.
Figure 2-2 shows the power, Ethernet, and serial port connection locations
on the serial device server rear panel.
1
3 4
Figure 2-2. Rear Panel of a Four-Port Serial Device Server
3 Default Hostname
Ethernet Configuration, for more
5
4 Serial Ports 1 and 2
5 Serial Ports 3 and 4 (on 4-Port Models Only)
2-3 ENET-232 and ENET-485 Series User Manual
Chapter 2 Installation
1
2
3
Configuring the Network