National Instruments ENET-232 Series User Manual page 75

Serial, for windows 2000/nt 4.0 and linux x86/solaris 2.x
Hide thumbs Also See for ENET-232 Series:
Table of Contents

Advertisement

© National Instruments Corporation
How can I determine which firmware version is running on my serial
device server?
Use NI Ethernet device configuration to view the firmware version of the
serial device server. Complete the following steps:
1.
Verify that the specific serial device server is on the same subnet as
your computer.
2.
Run
, which is in the
visaconf
installation. Click on Add Static, which brings up the Add New Static
Resource window. From the Select the interface listbox, click NI
ENET Serial Box. from the right pane, click Browse... to bring up the
NI Ethernet Device Configuration window.
3.
Select your serial device server and then click Properties. The
firmware version is listed in the Properties window.
What is the maximum baud rate supported?
The maximum baud rate supported is 460.8 kbits/s for RS-485 and
230.4 kbits/s for RS-232.
My application worked with a board interface, but it times out when
I use the serial device server interface. What should I do?
Because the serial device server is a network device, it is dependent on
network conditions for timely communications. An unpredictable delay
is associated with using the remote serial ports. Applications may require
longer serial timeouts to compensate for this delay. However, different
applications handle serial timeouts differently, and each must be adjusted
individually to account for your network conditions.
What do I do if diagnostics shows errors?
Refer to the troubleshooting sections of this appendix for specific
information about what might cause diagnostics to show errors. If you
already have completed the troubleshooting steps, contact National
Instruments.
How do I communicate with my instrument over the serial bus?
Refer to the documentation that came from the instrument manufacturer.
The command sequences you use are dependent on the specific instrument.
The documentation for each instrument should include the serial
commands you need to communicate with it.
Appendix C
Troubleshooting and Common Questions
NIvisa
C-15
ENET-232 and ENET-485 Series User Manual
subdirectory of your

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enet-485 series

Table of Contents