Table of Contents
Advertisement
Chapter 5
Verify the Installation
Linux x86/Solaris 2.x
ENET-232 and ENET-485 Series User Manual
When you click Start, the diagnostics utility verifies the following:
•
The serial server software is installed properly.
•
The configuration of your hardware does not conflict with anything
else in your computer.
•
The serial server software can communicate with your serial device
server correctly.
If the test is successful, your serial device server and serial server software
are installed properly. Figure 5-2 shows the results of a successful test.
If the test fails, refer to Appendix C,
Common
Questions, to troubleshoot the problem.
Figure 5-2. Example of Serial Device Server Diagnostics Utility After Test
To verify hardware and software installation, run
the
subdirectory of your installation.
NIvisa
run-time engine to attempt to open and close each port. If the test is
successful, there are no ENET-Serial ports under the Unknown node; they
all are under the ASRL0 (ENET/Serial) node. Select any ENET-Serial
port under the Unknown node and press Enter. This brings up a dialog box
with a diagnostic message with more information on the error source. Refer
to Appendix C,
Troubleshooting and Common
the problem.
Troubleshooting and
5-2
, which is in
NIvisaic
uses the VISA
NIvisaic
Questions, to troubleshoot
ni.com
Advertisement
Table of Contents
