Table of Contents
Advertisement
© National Instruments Corporation
Select your serial device server and click Properties... for any of the
following reasons:
•
You need to configure an unconfigured IP address.
•
You need to change the current network parameters.
•
You previously used DHCP, but it is no longer available.
•
You are using DHCP and need to change the serial device server
hostname.
•
The IP address/hostname column displays an exclamation
point (!) next to your serial device server, indicating a
configuration problem. Refer to the
section for help resolving this problem.
•
You want to add or change a comment to help identify the device.
Click Refresh if you do not see your serial device server in the list of
Ethernet devices, or to discover a device that you recently added to the
network.
Click Exit (or Cancel) if you are using DHCP and you do not need to
change the hostname of the serial device server, or if you are finished
using NI Ethernet device configuration.
3-3
Chapter 3
Ethernet Configuration
Verifying the Hostname
ENET-232 and ENET-485 Series User Manual
Advertisement
Table of Contents
