Table of Contents
Advertisement
Troubleshooting and
Common Questions
Troubleshooting Network Problems
My Device Does Not Appear in the NI Ethernet Device
Configuration Window
Network Has DHCP But Does Not Configure The Device's Network
Parameters
© National Instruments Corporation
This appendix describes how to troubleshoot problems and answers some
common questions. The information in this appendix is arranged in the
following sections:
•
Troubleshooting Network Problems
•
Troubleshooting Hardware Problems
•
Troubleshooting Diagnostic Messages
•
Common Questions
•
Allow at least 90 seconds after powering on the device.
•
Confirm that the unit is connected to the network on the same subnet
as the host computer.
•
Click Refresh on the utility window to update the current network
information.
•
Refer to Chapter 3,
about NI Ethernet device configuration.
•
Use NI Ethernet device configuration to confirm that your device is set
to use DHCP.
•
Have your network administrator confirm that your network's DHCP
server is functional and that there are available IP addresses.
Ethernet
Configuration, for more information
C-1
ENET-232 and ENET-485 Series User Manual
C
Advertisement
Table of Contents
