Table of Contents
Advertisement
Note
The IP settings in Figure 3-3 are shown only as a format example.
© National Instruments Corporation
Consult your network administrator for more details. For more
information about DHCP, refer to the
Chapter 6,
Using Your Serial Device
2.
In the Properties window, select either Obtain an IP address
automatically (DHCP) or Use the following IP settings.
3.
If you select Obtain an IP address automatically (DHCP), you do
not need to enter any network parameters unless you want to change
the hostname of the Ethernet device. If you select Use the following
IP settings, enter the network parameters you have chosen for the host
IP address, subnet mask, gateway IP, and DNS server IP, as in the
example shown in Figure 3-3. Refer to the
section for more information.
4.
You can enter an optional comment to help you identify the device.
Using DHCP
Server.
Figure 3-3. Specifying IP Settings
3-5
ENET-232 and ENET-485 Series User Manual
Chapter 3
Ethernet Configuration
section in
Static IP Parameters
Advertisement
Table of Contents
