Table of Contents
Advertisement
© National Instruments Corporation
3.
Locate the bias resistors. Figure 6-4 shows the bias resistors as black
rectangles and circles. Each port has four bias resistors.
Figure 6-4. Location of Bias Resistors
4.
Remove the bias resistors by gently lifting them out of the sockets.
5.
Install new resistors that are trimmed to fit in the sockets.
6.
Slide the top cover backwards over the baseplate and reinstall the
four screws.
Chapter 6
6-13
ENET-232 and ENET-485 Series User Manual
Using Your Serial Device Server
Advertisement
Table of Contents
