Hardware Configuration and Installation
Chapter 2
Step 6. Connect the MXIbus Cable
There are two basic types of MXIbus cables. MXIbus cables can have either a single connector
on each end, or a single connector on one cable end and a double connector on the other end.
Your VXI-AT2022 kit comes standard with a cable with single connectors on each end.
Nonpolarized Cables
The cable with a single connector on each cable end is nonpolarized and may be installed with
either end connected to either device. Be sure to tighten the screw locks to ensure proper pin
connection. See Figure 2-12.
Art not available in PDF version of document.
Figure 2-12. MXIbus Single-Ended Cable Configuration
VXI-AT2022/NI-VXI SCO UNIX Getting Started
2-22
© National Instruments Corporation