Using The Reset Button; Understanding Led Indications - National Instruments sbRIO-9601 User Manual

USER1 Switch
NO FPGA Switch

Using the Reset Button

Understanding LED Indications

NI sbRIO-9601/9602/9602XT User Guide
startup and disabling VIs from launching at startup, refer to the Running a
Stand-Alone Real-Time Application (RT Module) topic of the LabVIEW
Help.
You can define the USER1 switch for your application. To define the
purpose of this switch in your embedded application, use the RT Read
Switch VI in your LabVIEW RT embedded VI. For more information
about the RT Read Switch VI, refer to the LabVIEW Help.
Push the NO FPGA switch to the ON position to prevent a LabVIEW
FPGA application from loading at startup. The NO FPGA switch overrides
the options described in the
download bit files to flash memory from a LabVIEW project regardless of
switch position. If you already have an application configured to launch at
startup and you push the NO FPGA switch from ON to OFF, the startup
application is automatically enabled.
Pressing the Reset button reboots the processor. The FPGA continues to
run unless you select the Autoload VI on device reboot boot option. Refer
to the Boot Options section for more information.
1
2
1 FPGA 2 USER
Boot Options section. After startup you can
3 POWER
Figure 12. NI sbRIO Device LEDs
16
3
4
4 STATUS
ni.com