Table of Contents
Advertisement
Mount the SmarTrax Controller
When choosing the location for the SmarTrax controller, consider the following points:
•
The controller is not weatherproof. Mount the controller in the vehicle's cab within easy reach of the
operator.
•
Mount the controller in a location where it will not impede the operator's ability to control the vehicle and
where other components within the cab will not strike or jar the controller during normal operation.
•
Ensure that all cabling is routed to avoid tripping hazards and prevent crimping or breaking the cables
during normal operation.
To Install the SmarTrax Controller
Select the preferred location for the controller using the previous recommendations and mount the
1.
controller.
Connect the large, round connector on the SmarTrax console cable harness (P/N 115-0171-775) to the
2.
back of the controller box.
Connect your receiver or source of DGPS to the connector labeled 'DGPS.'
3.
Connect the console or lightbar providing machine guidance to the connector labeled 'LIGHTBAR.'
4.
Insert the power cable (P/N 115-0171-465) to the Power connector on the controller box.
5.
Route the power leads to the vehicle's battery and connect.
6.
Connect the red power lead on the positive battery terminal.
a.
Connect the black power lead on the negative battery terminal.
b.
Manual No. 016-0190-060
Wiring and Electrical Connections
19
Advertisement
Table of Contents
