Fitting The Electronics - Fein BOZ 32-4M Repair Instructions

Rotary Drills
Fitting

9.2.8 Fitting the electronics

Steps that must be completed:
- Fitting the stator
Tools:
- Torx T15
- PH2 cross-tip screwdriver
3
4
6
C-SC_CSSM
2
1
5
Version 1.0
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation.
1. Position the brush holder (1).
2. Screw in the two screws (2).
3. Position the cable (3).
4. Screw in the screw (4).
5. Repeat steps 1 to 4 on the opposite side of the machine.
6. Position the electronics (5).
7. Screw in the two screws (6).
8. Connect all cables as shown in the connection diagram.
01.01.2019 Page 42 of 47