Expansion Cards For Slot 2; Guide To Installation Of Expansion Cards In Slot 2; Option "F2", Controlled Fan - Kollmorgen S70101 Instruction Manual

Kollmorgen
10.2

Expansion cards for slot 2

10.2.1

Guide to installation of expansion cards in slot 2

Boundary of SLOT 2
10.2.2

Option "F2", controlled Fan

To reduce noise emission the servo amplifiers can be ordered with the built-in option card
F2. This option cannot be built-in later. The F2 option card fits to slot2 or 3 (see part num-
ber scheme on p.22).
Option card F2 can be used combined with a card in slot 1 even if it is plugged to
slot 2!
Function
The fan is switched on and off or runs with 50% rated speed depending on temperature
and brake power. That reduces the average noise emission.
Switching temperature
Monitoring
Internal temperature
Heat sink temperature
Brake resistor (internal)
S701...S724 (single channel STO) Instruction Manual
12/2010a
The method of installing the expansion card in slot 2 is
the same as that described for slot 1 (see p.107).
l
Remove the lower crosshatched area of the front
film (labeled slot 2).
l
Lever out the cover plates under the film.
l
Push the expansion card into the slot.
l
Use the screws provided to fasten the front plate
of the expansion card in place.
Fan off Fan ~50%
< 55°C
< 60°C
< 20W
Expansions
Fan on
~ 58°C > 65°C
~ 65°C > 75°C
~ 30W > 45W
121