Fan Assembly - Kollmorgen S70101 Instruction Manual

Mechanical Installation
7.5

Fan assembly

The fan does not require wiring. Built-in connectors in the fan casing plug into sockets on
the underside of the S700.
Remove the fan before mounting the servo amplifier and replace it again
afterwards.
Mounting/removing the fan (models S701...712)
Mounting/removing the fan (model S724)
48
12/2010a
S701...S724 (single channel STO) Instruction Manual
Kollmorgen
Removal:
Gently squeeze the fan cas-
ing together lengthwise and
pull the fan casing down.
Mounting:
Position the fan so that the
green connector is aligned
with the socket in the S700.
Push the fan onto the con-
nector until the fan casing
clicks into place. Gently
squeeze the fan casing
together lengthwise to
check that it is fully enga-
ged.
Removal:
Gently squeeze the fan cas-
ing together crosswise and
pull the fan casing down.
Mounting:
Position the fan so that the
green connector is aligned
with the socket in the S700.
Push the fan onto the con-
nector until the fan casing
clicks into place. Gently
squeeze the fan casing
together crosswise to check
that it is fully engaged.