Table of Contents
Advertisement
Reload WINCE Factory CMOS Defaults (Q1000g/Q1010m)
This selection restarts the workstation and populates the Boot Device
Prioritization fields to boot from a USB Hard Drive containing Windows
Embedded CE 6.0 R3. Press [Enter] and [Y] to proceed.
Reload Win32 Factory CMOS Defaults (Q1000g/Q1010m)
This selection restarts the workstation and populates the Boot Device
Prioritization fields to boot from a USB Hard Drive containing POSReady
2009. Press [Enter] and [Y] to proceed.
Reload WINCE Factory Default Settings (Q2010g/Q2011d)
This selection restarts the workstation and populates the Boot Device
Prioritization fields to boot from a USB Hard Drive containing Windows
Embedded CE 6.0 R3. Press [Enter] and [Y] to proceed.
Reload USB WIN32 Factory Default Settings (Q2010g/Q2011d)
This selection restarts the workstation and populates the Boot Device
Prioritization fields to boot from a USB Hard Drive containing POSReady
2009. Press [Enter] and [Y] to proceed.
Reload SATA WIN32 Factory Default Settings (Q2010g/Q2011d)
This selection restarts the workstation and populates the Boot Device
Prioritization fields to boot from an optional SATA Disk Drive containing
POSReady 2009. Press [Enter] and [Y] to proceed.
Workstation 5A Setup Guide - Fourth Edition
NOTICE
Selecting any of the factory defaults re-enables some
fields in the ODM Tab including the IO Panel USB Ports,
and the Recovery Password. In BIOS Version Q2011d, if
the CF Interface is disabled, resetting defaults will
re-enable it.
Workstation 5A BIOS
Exit
2-9
Advertisement
Table of Contents
Need help?
Do you have a question about the MICROS Workstation 5A and is the answer not in the manual?
Questions and answers