Table of Contents
Advertisement
Installing and Operating the Workstation 5A
Workstation 5A Recovery
Workstation 5A Recovery
The Workstation 5A offers two methods of recovery, depending on the
Operating System installed.
For Windows Embedded CE 6.0 R3 clients, WINCE Factory Restore is
provided. For details about the internal operation of Factory Restore, see
Chapter 3.
For WIN32, the optional POSReady 2009 Recovery CF can restore a factory or
customer image to a USB Hard Drive or optional SATA Drive in minutes.
Two methods of starting a Factory Restore or the Recovery CF are available;
the Recovery Button or the ODM tab in the BIOS System Configuration
Utility.
Recovery Button
The Recovery Button is a recessed SPST switch accessed from the base of
the workstation. It can be activated by any object less than 2mm in
diameter. The location is shown below.
BIOS ODM Tab
In some cases, it may not be practical to access the recovery button. The
ODM Tab in the BIOS System Configuration Utility can be used to start
Factory Restore or the Recovery CF. A USB Keyboard is required.
BIOS - Password and Login Requirements
Several recent BIOS releases may now prompt for a login and or
password when the Recovery Button or ODM tab is used to start
recovery. A list of BIOS versions and requirements can be found on the
next page.
4-26
Figure 4-18: Recovery Button Location
Workstation 5A Setup Guide - Fourth Edition
Advertisement
Table of Contents
Need help?
Do you have a question about the MICROS Workstation 5A and is the answer not in the manual?
Questions and answers