Table of Contents
Advertisement
System Setup
To add a server in the Server Config list
To modify the setup for a server in the list
NOTE:
3-48
Follow this procedure to add a server to the list:
1. Select Add.
Figure 3-16. Server Configuration
2. Add the server's name in the Server Name field.
3. Add the server's IP address in the IP-Address field.
4. Select Check to verify that the server is found.
This check is a network Ping. A symbol to the right of the
Check button indicates the result:
•
A green check mark next to the Check button indicates
that the IP-Address was found on the network.
•
A red mark indicates that the IP address was not found.
Troubleshooting tips:
•
No network connection between the Ultrasound system
and the server.
•
The wrong IP Address.
Both the pre-defined servers and new servers can be modified.
Follow this procedure to modify the setup for a server in the
list:
1. Highlight the server you want to modify.
2. Select Modify.
3. Update the information as needed.
4. Select Check to verify that the server is found.
This check is a network Ping. A symbol to the right for the
Check button indicates the result:
•
A green check mark next to the Check button indicates
that the IP-Address was found on the network.
•
A red mark indicates that the IP address was not found.
Troubleshooting tips:
–
Vivid E80/E90/E95
GC091052 Rev. 3
Service Manual
Advertisement
Table of Contents
Troubleshooting
