Peripherals Replacement; Dvd R/W Drive Replacement - GE Vivid E80 Service Manual

Hide thumbs Also See for Vivid E80:
Table of Contents

Advertisement

DVD R/W drive replacement

Preparations
Remove the DVD drive
NOTE:
Install the DVD drive
Vivid E80/E90/E95
GC091052 Rev. 3

Peripherals replacement

When preparing for the replacement, you must perform the
following steps:
1. Power down the Ultrasound system.
2. Disconnect the Mains Power Cable from the wall outlet.
3. Disconnect all probes and external I/O cabling.
4. Remove the Side Covers.
5. Remove the Top Cover.
Follow this procedure to remove the DVD drive:
1. Raise the Top Console to the highest level.
2. Remove the 4 screws securing the right side of the DVD
drive.
3. Tilt the Front Cover forward just until the Column Cover stop
tabs clear.
4. Raise the Column Cover to access and remove the 4
screws securing the left side of the DVD drive.
5. Disconnect the cables to the DVD drive.
6. Slide the DVD drive out the front of the Ultrasound system.
If Power Connection is different on new and old DVD drive:
Move the DVD Interface Board, Part Number 5301204, from
the old DVD drive that you removed, to the new DVD drive.
Follow this procedure to install the DVD drive:
1. Slide the DVD drive into position.
2. Install the 8 screws to secure the DVD drive.
Service Manual
Peripherals replacement
8-109

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vivid e90Vivid e95

Table of Contents