Bep I/O Board - GE Vivid E80 Service Manual

BEP I/O Board

General description
Location
Connectors on the I/O Rear Panel
Connectors on the I/O Side Panel (inside the Ultrasound system)
–
Vivid E80/E90/E95
GC091052 Rev. 3
• The BEP I/O board is the interface between the BEP and
the rest of the Ultrasound system.
• The BEP I/O board is plugged into a connector on the BEP's
main board.
• The DVI signals are received via cable from the Display
GPU.
The I/O board is located inside the BEP with some connectors
available on the rear of the Ultrasound system and some
available inside the Ultrasound system.
• 2 x USB 2.0 (via HUB)
• Audio Line Out L+R
• DVI-out (external monitor)
• Giga bit LAN
• Test connector (used by manufacturing)
• 8 x USB 2.0
• 2 x eSATAp
• DVI-D out (System Monitor)
• Digital Audio out
• Operating Panel Audio out
Service Manual
Input and Output (I/O) modules
5-45