Replacement Procedures
Install the Handle, Left Top / Handle Right Top
Palm Rest ASSY replacement
Read and follow
WARNING
Preparations
8-58
Follow this procedure to install the Handle, Left Top / Handle
Right Top:
1. Remove the Gel Cups (if present).
2. Install the Handle, Left Top / Handle, Right Top by pressing
them into the UI Frame, Lower.
3. Install the Gel Cups you removed in step 1.
4. Install the Operating Panel, Lower.
5. Install the Operating Panel Upper.
Energy Control and Power Lockout for Vivid E80/E90/E95.
When servicing parts of the Ultrasound system where there is
exposure to voltage greater than 30 volts:
1. Follow LOCK OUT/TAG OUT procedures.
2. Turn off the breaker.
3. Unplug the Ultrasound system.
4. Maintain control of the Ultrasound system power plug.
5. Wait for at least 30 seconds for capacitors to discharge as
there are no test points to verify isolation.
Ultrasound System components may be energized.
When preparing for the replacement, you must perform the
following steps:
1. Power down the Ultrasound system.
2. Disconnect the Mains Power Cable from the wall outlet.
3. Disconnect all probes and external I/O cabling.
4. Remove the Rotary buttons below the Touch screen and the
Volume button.
5. Remove the Operating Panel, Upper.
6. Remove the Operating Panel, Lower. Place it on a clean
surface with the front down.
–
Vivid E80/E90/E95
GC091052 Rev. 3
Service Manual