Remote Supervisor Adapter Ii Refresh - IBM TS7600 with ProtecTIER Software Upgrade Manual

12. In the Login window, enter USERID as the username and PASSW0RD (with a
13. In the Remote Supervisor Adapter II Refresh 1 Welcome window:
Figure 9. Remote Supervisor Adapter II Refresh 1 Welcome window
14. In the ASM section of the left-side navigation pane of the Remote Supervisor
15. In the Static IP Address field, change the last octet to an address value that is
16. In the Netmask field, enter: 255.255.255.0.
17. Leave the Gateway field blank.
18. Click Save.
86
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
zero) as the password, and then click OK.
Note: The username and password are case sensitive and must be entered in
all uppercase.
The Remote Supervisor Adapter II Refresh 1 Welcome window opens.
a. Use the Inactive session timeout value dropdown list to specify a
reasonable amount of time which will keep your session active until you
can complete your task. (Ten minutes should suffice.)
Do not select the No Timeout setting, as this will prevent anyone else
from logging into the RSA until you have logged out.
b. Click Continue. See Figure 9.
You are now logged into the server's RSA.
c. Do one of the following, as appropriate:
v If you are altering the default IP address of the RSA on Server B to
avoid an IP address conflict, continue with step 14.
v If you are connecting to the RSA to establish a command line interface
to a stand-alone server, or either server in a cluster, skip the remaining
steps in this procedure and go to "Enabling Remote Control" on page
87.
Adapter II Refresh 1 Welcome window, click Network Interface.
lower than the default of 254.
For example: 172.31.1.253.