Installing Protectier Manager On Linux - IBM TS7600 with ProtecTIER Software Upgrade Manual

10. If you configured replication, the user must create and configure the
11. If you did not configure replication, the customer can now resume use of their

Installing ProtecTIER Manager on Linux

Use the procedure below to upgrade the version of ProtecTIER Manager on a
Linux-based workstation.
Before you begin
Important: The procedure below assumes that the workstation on which
ProtecTIER Manager is being installed has a Linux graphical user interface (GUI).
A GUI is required for ProtecTIER Manager operation on Linux.
Procedure
To upgrade the version of ProtecTIER Manager on a Linux-based workstation:
34
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
6. Select the location where the program icons will be created:
v In a new Program Group – Creates a new program group in the Program
list of the Start menu.
v In an existing Program Group – Adds the shortcut to an existing program
group in the Program list of the Start menu.
v In the Start Menu
v On the Desktop
v In the Quick Launch Bar
v Other – Enables you to enter a path location for the shortcut, or to browse
for a location by clicking Choose.
v Don't create icons – No shortcuts are created.
Note: When relevant, you can select Create Icons for All Users to create a
shortcut in the defined location for all user accounts on the workstation.
7. Click Next.
The Pre-Installation Summary window opens.
8. Review the Summary window, and then click Install to start the installation.
The Installing ProtecTIER Manager window opens.
When the installation is complete and ProtecTIER Manager has been
successfully installed, the Install Complete window opens.
9. Click Done.
The ProtecTIER Manager Installation wizard closes and the upgrade process is
complete.
replication grid before replication is fully functional. Turn the system over to
the customer, and refer them to the IBM System Storage ProtecTIER User's
Guide for Enterprise Edition and Appliance Edition, IBM form number GA32-0922
for detailed information.
ProtecTIER system.
1. Set the resolution to 1280 x 1024.
This is the optimal resolution for viewing the ProtecTIER Manager GUI.
2. Insert the IBM System Storage ProtecTIER Enterprise Edition V3.1 into the
CD-ROM drive of the designated ProtecTIER Manager workstation.
3. Run the ProtecTIER Manager installer. To do so: