Using The Tssc Or A Service Laptop - IBM TS7600 with ProtecTIER Software Upgrade Manual

Procedure
10. For the OS USB selection, choose: Linux OS.
11. Press the down-arrow key to highlight Save Values and Reboot RSA and
12. Press Esc three times.
13. Select Save Settings.
14. When the save is complete, exit the Configuration/Setup Utility screen.
15. Return to the procedure that sent you here.

Using the TSSC or a service laptop

Use the procedure below to make a connection to the server's RSA using the TSSC
or a service laptop.
Procedure
84
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
1. Connect a USB keyboard and graphics-capable monitor to Server B.
2. Log into the server with the ID: root and the password: admin.
3. From command line, type: reboot <enter>
4. When the IBM logo displays, press F1 to enter Setup mode.
5. Select Advanced Setup → RSA II Settings.
6. At DHCP Control, select Use Static IP.
7. For the Static IP Address, change the last octet to an address value that is
lower than the default of 254.
For example: 172.31.1.253.
8. For the Netmask, enter: 255.255.255.0.
9. Leave the Gateway field blank.
then press <enter>.
The system will pause for a few moments while the RSA reboots. When the
reboot completes, a pop-up message displays.
You are returned to the Configuration/Setup Utility screen.
The server reboots and Server B's RSA IP address is now unique.
1. If you are using the TSSC, skip ahead to step 10 on page 85. Otherwise,
continue with step 2.
2. Connect an Ethernet cable from the Ethernet port on your laptop to the SYS
MGMT (RSA port) on Server B. See Figure 7 on page 85.