Updating Imm Firmware Using The Web Interface - IBM TS7600 with ProtecTIER Software Upgrade Manual

Updating IMM firmware using the web interface

This topic describes how to update Integrated Management Module (IMM)
firmware using the web interface.
Procedure
10. To complete the update process, click Continue. A progress indicator is
11. Click the option Restart IMM. Click the Restart button.
12.
13. Click OK to close the current browser window.
14. Wait a few minutes to allow the IMM to complete its restart before logging
94
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
1. Connect an Ethernet cable from the Ethernet port on your laptop to the SYS
MGMT port on the 3958 DD4 server (see Figure 11 on page 90).
2. To facilitate opening of a Web browser on your laptop, perform preparatory
steps 4 on page 90 through 13 on page 91. Then return to this procedure.
Note: If you are using the TSSC, perform only steps 12 on page 91 and 13 on
page 91. Then return to this procedure.
You have already opened the web browser with the appropriate IP address of
the IMM Web interface to which you have to connect.
Note: The IMM assigns an initial, default static IP address of 192.168.70.125.
3. Type your user name and password on the Login page. If the user name and
password have been changed, obtain them from the system administrator.
Otherwise, type the initial values.for the IMM:
User name: USERID
Password: PASSW0RD (with a zero, not the letter O)
4. Select a timeout value, in minutes, in the field provided. If your browser is
inactive for that number of minutes, the IMM logs you off the web interface.
5. Click Continue to start the session. The browser displays the System Health
page, which gives you a quick view of the system status.
6. In the navigation frame, click Firmware Update under Tasks. Click Browse.
7. Navigate to the IMM firmware file (ibm_fw_imm_yuooxxx_linux_32-64.bin)
and click Open. The filename, including the full path, is displayed in the box
beside Browse.
8. To begin the update process, click Update. A progress indicator is displayed as
the file is transferred to temporary storage on the IMM. After the file transfer
is complete, a confirmation page is displayed.
9. Verify that the upd file shown on the Confirm Firmware Update page is the
correct update file. If not, click the Cancel button.
displayed as the firmware on the IMM is flashed. A confirmation page is
displayed to verify that the update is successful.
Click OK to confirm that you want to restart the IMM.
Note: Restarting the IMM will disconnect your current session.
into the IMM again.