IBM TS7600 with ProtecTIER Software Upgrade Manual page 49

a. From the Linux desktop, double-click the CD-ROM icon, and then
double-click the installation folder for the version of Linux you are using.
Linux for version 64 or Linux32 for version 32
b. From the installation folder, select the InstallLinuxXX.bin file (where XX is
64 or 32, depending on the folder you are in) and drag the file onto the
desktop.
c. Close any open windows.
d. Right-click on any open area of the desktop, and from the menu that
displays, click Open Terminal.
The terminal window opens.
e. At the terminal command prompt, change to the Desktop directory. Enter
the command:
cd Desktop <enter>
Note: The above command is case-sensitive. Type it using a capital "D".
f. From the Terminal Window's Desktop directory, run the ProtecTIER
Manager installer:
In all commands below, XX is 64 or 32.
./InstallLinuxXX.bin and press <enter>
If the message: Permission Denied displays, enter the following commands:
chmod +x InstallLinuxXX.bin <enter>
./InstallLinuxXX.bin <enter>
The IBM ProtecTIER Manager Wizard Introduction screen displays.
4. Click Next.
Two sequential Software License Agreement screens display.
5. Read the terms for each license agreement, indicate your acceptance, and then
click Next.
The Choose Install Folder screen displays.
6. Specify the location for the ProtecTIER Manager program files. To do so,
perform one of the following:
v Enter the path to the location where the ProtecTIER Manager program files
will be installed.
v Click Choose to browse for a location.
Note: Click Restore Default Folder to revert to the default installation path.
7. Click Next.
The Choose Link Folder screen displays. See Figure 3 on page 36.
Chapter 6. Upgrading ProtecTIER Manager
35