Factory-Default Server Ip Addresses For A Clustered Vtl Protectier System (3958 Dd4 Or 3958 Ap1) - IBM TS7600 with ProtecTIER Software Upgrade Manual

Factory-default server IP addresses for a clustered VTL TS7650G
3958 DD4 or TS7650 Appliance
Table 8. Factory-default server IP addresses for a clustered VTL ProtecTIER system (3958 DD4 or 3958 AP1)
TS7650 clustered VTL system
Node A (the server located in
the lower part of the rack)
Node B (the server located in
the upper part of the rack)
Component
Server A
Note: By default, the TS7650 servers use the IP address range 10.0.0.50 through
10.0.0.59 for the power control network. The server IP addresses do not change
from frame to frame.
Server A
Server A
Server A
Server A
Server A
Network Power Switch
Server B
Note: By default, the TS7650 servers use the IP address range 10.0.0.50 through
10.0.0.59, for the power control network. The server IP addresses do not change
from frame to frame.
Server B
Server B
Server B
Server B
Server B
Network Power Switch
Port Function
eth0 Customer
local LAN
eth1 Cluster
network 1
eth2 Replication
network 1
eth3 RAS
eth4 Cluster
network 2
eth5 Replication
network 2
N/A
eth0 Customer
local LAN
eth1 Cluster
network 1
eth2 Replication
network 1
eth3 RAS
eth4 Cluster
network 2
eth5 Replication
network 2
N/A
Appendix D. IP address worksheet
Factory Default IP
Address
192.168.10.161
10.0.0.51
192.168.20.1
172.31.1.xx
10.0.0.51
192.168.21.1
10.0.0.50
192.168.10.162
10.0.0.52
192.168.20.2
172.31.1.xx
10.0.0.52
192.168.21.2
10.0.0.50
63