IBM TS7600 with ProtecTIER Software Upgrade Manual page 38

22. Extract the installation files into a new directory within the /install directory.
23. After the files are extracted, list the /install directory contents to get the name
24. Change to the <ProtecTIER directory name> directory. Enter the following
25. Eject the IBM System Storage ProtecTIER Enterprise Edition V3.1 from the
26. Start the autorun utility. Enter the following command:
27. Press <enter> to restart the server.
24
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
cd /install <enter>
Enter the following command:
tar -xvf <tar filename>.tar <enter>
The <filename> directory is created. For example: PT_TS7650G_V3.1.0.1
-full.x86_64.tar.
of the ProtecTIER directory you will change to in the next step. Enter the
command:
ls <enter>
command:
cd <directory name> <enter>
For example: cd PT_TS7650G_V3.1.0.1 -full.x86_64
Note: You will perform the remainder of the installation from this directory.
CD-ROM drive. Enter the command:
eject <enter>
./autorun -f <enter>
A series of messages display as the autorun utility installs the ProtecTIER
v3.1.x.x upgrade, and performs the additional tasks outlined in Chapter 4,
"Installing and configuring the ProtecTIER v3.1.x.x upgrade," on page 11.
Execution of autorun can take up to 15 minutes.
During the autorun process, you may be prompted to upgrade the firmware
level of the attached storage. Entering Yes will instruct autorun to check the
firmware level, and update it to current release levels, as necessary. Because of
the varied amounts of attached storage, the firmware check may take several
minutes to complete. If it is determined that the firmware requires an update,
the process may take up to an hour.
Upon completion, the following message displays:
The system will now reboot!
After boot, please set user to ptadmin by invoking 'su - ptadmin'
(default password is ptadmin).
Press <CR> to continue...
Notes:
v While the server is restarting, verify that the DVD was ejected in step 25. If
not, press the button on the front of the disc drive to manually eject the
DVD, now.
v During the boot cycle one or more warning or failure messages, including
ones specific to Eth4 and Eth5, might display. These messages are expected.
v During the boot cycle, the ProtecTIER file systems are mounted. If the
message: Running... displays, press <enter> to proceed to the login
prompt.
v During the code upgrade process, the administrator assigned to receive
email alerts might receive several email messages relating to condition
changes on the server being upgraded. Typical email alerts relate to: vtfd
services not running, power supply good faults, configuration information,