IBM TS7600 with ProtecTIER Software Upgrade Manual page 23

6. Click Restart in the lower-left area of the screen, and then click OK when
prompted to restart.
After the restart completes, the message below displays:
TSSC Not Installed. Proceed. . .
This will install the Console onto /dev/sda which will erase everything
on that device
Continue? ('yes' or 'no')
Abort
7. Type: y and press <enter>.
The hard drive re-image process begins.
8. When the re-image is complete, the TSSC restarts automatically and the CD is
ejected from the disc drive.
After the initial reboot, the software discovers the machine type and model
number of the computer, and automatically configures the appropriate drivers
and settings. The TSSC is then automatically restarted a second time. During
the second restart, the start-up background and text might look slightly
different. The second boot displays a login screen. If the software determines
that the machine type is not 6579, 6792, 8480, 8482, 8485, 8836, or 8849, a
warning message will display on the screen and the TSSC will halt. This will
continue each time the TSSC is powered on. Similar symptoms occur after
software installation if the TSSC is unable to determine its machine type and
model.
Note: If a product with a machine type of 6579, 6792, 8480, 8482, 8485, 8836,
or 8849 reports a different machine type during an installation, the BIOS may
have been corrupted. Restart the server, and make the appropriate selection
during the restart to enter BIOS setup. In the BIOS, check the machine type
that is configured. If the machine type does not match the specific server, you
should reinstall the system BIOS. Refer to the server documentation to
reinstall the BIOS and to set the correct machine type.
9. Restore the TSSC configuration from the backup. Refer to the IBM System
Storage TS3000 System Console (TSSC) Maintenance Information (on the IBM
System Storage TS7650 with ProtecTIER Publications CD) for instructions.
10. Once the TSSC configuration has been successfully restored, the re-image
process is complete.
You or the customer can go on to Chapter 4, "Installing and configuring the
ProtecTIER v3.1.x.x upgrade," on page 11, or the previous version of this
document to upgrade to 2.4.x.x from 2.2.x.x or 2.3.x.x, as applicable
Chapter 3. Re-imaging the TSSC microcode
9