IBM TS7600 with ProtecTIER Software Upgrade Manual page 32

In addition, each virtual interface containing more than one physical interface
(configured as a bond) needs to be configured with a load balancing method.
Currently, a server with 10 Gbe interfaces does not support bonding, which means
that each of the server virtual interfaces contain only a single physical interface.
No physical interfaces can be reassigned. The load balancing method does not
matter, in this case, because the virtual interface contains only a single physical
interface. For a server with 1Gbe interfaces, bonding is supported, and the
recommended load balancing method is LACP with L3L4.
For more information about bonding, the different load balancing methods, and
whether to configure bonds at all, refer to the Best Practices Guide for IBM System
Storage TS7600 ProtecTIER Deduplication Solutions, IBM form number GA32-0924.
The Best Practices Guide also contains configuration examples and instructions.
Procedure
The following procedure describes how to perform the tasks described in the
previous paragraph.
18
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
1. On the server, if it is not already displayed, access the ProtecTIER System
menu by typing menu in the prompt..
2. Select the ProtecTIER Configuration (...) option. Type the corresponding
number and press <enter>. The ProtecTIER Configuration (...) menu is
displayed.
+------------------------------------------------+
| RAS Text Based Menu running on rassmb2
+------------------------------------------------+
| 1) Check if RAS service is running
| 2) Start RAS
| 3) Stop RAS
| 4) Get RAS Version
| 5) Get PT Code Version
| 6) Display Firmware Levels
| 7) Manage Configuration (...)
| 8) check PT Services Status (...)
| 9) System Health Monitoring (...)
| 10) Problem management (...)
| 11) Call Home Commands (...)
| 12) Collect Logs (...)
| E) Exit
+------------------------------------------------+
>>> Your choice?
3. Select the IP Network configuration (...) option. Type the corresponding
number and press <enter>. The IP Network configuration (...) menu is
displayed:
|
|
|
|
|
|
|
|
|
|
|
|
|
|