Enabling Remote Control; Configuring Rsa Keystrokes - IBM TS7600 with ProtecTIER Software Upgrade Manual

An Alert dialog opens.
19. Read the alert and then click OK to continue.
20. Close the ASM window.
The RSA IP address on Server B is now unique.
21. On the TSSC or service laptop, open a browser window.
22. In the Address Bar area of the browser window, type the unique RSA IP
address that you set in step 15 on page 86 and then press <enter>.
23. In the Login window, enter USERID as the username and PASSW0RD (with a
zero) as the password, and then click OK.
Note: The username and password are case sensitive and must be entered in
all uppercase.
The Remote Supervisor Adapter II Refresh 1 Welcome window opens.
24. In the Remote Supervisor Adapter II Refresh 1 Welcome window:
a. Use the Inactive session timeout value dropdown list to specify a
reasonable amount of time which will keep your session active until you
can complete your task. (Ten minutes should suffice.)
Do not select the No Timeout setting, as this will prevent anyone else
from logging into the RSA until you have logged out.
b. Click Continue.
See Figure 9 on page 86.
25. Go to "Enabling Remote Control."

Enabling Remote Control

Use the procedure below to enable remote control.
About this task
Procedure
1. In the Remote Supervisor Adapter II Refresh 1 window, click Remote Control
found in the left-hand menu under the IBM logo.
2. In the Remote Control window, click Start Remote Control in Single User
Mode.
The ASM Remote Control window opens.
Note: If the browser on the TSSC or your laptop is configured to block
pop-ups, temporarily disable this function. Accept any Java versions that may
appear on the screen, as well as any Windows security prompts displayed as a
result of trying to open this window.
3. Once remote control is established, go to "Configuring RSA Keystrokes."

Configuring RSA Keystrokes

Use the procedure below to specify unique keystroke combinations for use during
RAS package configuration.
About this task
Procedure
1. In the ASM Remote Control window:
Appendix H. Making a server connection through the Remote Supervisor Adapter (RSA)
87