IBM TS7600 with ProtecTIER Software Upgrade Manual page 30

13. Insert the IBM System Storage ProtecTIER Enterprise Edition V3.1 into the
14. When the drive light stops blinking, enter the following commands:
15. Change to the local installation directory. Enter the command:
16. List the DVD contents to determine the name of the installation file. Enter the
17. From the list displayed, locate the file with the .tar extension and copy it to
18. Change to the /install directory. Enter the command:
19. Extract the installation files into a new directory within the /install directory.
20. After the files are extracted, list the /install directory contents to get the name
21. Change to the <ProtecTIER directory name> directory. Enter the command:
22. Eject the IBM System Storage ProtecTIER Enterprise Edition V3.1 from the
23. Start the autorun script. Enter the command:
16
IBM System Storage TS7600 with ProtecTIER: Software Upgrade Guide
ls <enter>
When only the .tar file for the code level currently running on the server
remains in the /install directory, the file removal is complete. Go on to step
13.
server's CD-ROM drive.
mkdir -p /mnt/cdrom <enter>
mount /dev/cdrom /mnt/cdrom <enter>
The following output displays:
mount: block device /dev/cdrom is write-protected. mounting read-only
cd /mnt/cdrom <enter>
command:
ls <enter>
the /install directory on the server's hard drive. Enter the command:
cp <filename>.tar /install <enter>
Tip: If you start entering the filename by typing: cp PT and pressing the <Tab>
key, Linux will attempt to fill in the remainder of the command string for you.
If Linux cannot complete the entire command string, it means that multiple
files with similar filenames exist in the directory. Manually type in the next
character in the filename and press <Tab> again, to allow Linux to complete
the string. This method of entering long command strings helps reduce the
potential for typing errors.
Note: The file copy can take up to five minutes to complete.
cd /install <enter>
Enter the command:
tar -xvf <tar filename>.tar <enter>
The <filename> directory is created. For example: PT_TS7650G_V2.5.0.1
-full.x86_64.tar.
of the ProtecTIER directory you will change to in the next step. Enter the
command:
ls <enter>
cd <directory name> <enter>
For example: cd PT_TS7650G_V2.5.0.1 -full.x86_64
Note: You will perform the remainder of the installation from this directory.
CD-ROM drive. Enter the command:
eject <enter>