How To Manually Re-Authorize The Device; Client Certificate Option; Passwords; About Passwords - Magtek ExpressCard 2000 User's Installation And Operation Manual

8 - Configuration

8.2.2 How to Manually Re-Authorize the Device

To re-authorize the device and test the Internet connection used for re-authorization, follow these steps:
1) Make sure the device has been authorized once in the past with assistance from MagTek Support
Services. The device can not be manually re-authorized until a user has put it through that process.
2) If the EC2000 is not already displaying the
3) Press the button to display the
Menu
4) Press the Settings
5) Press the
Authorize/Deauthorize
6) If you want to test the connection to MagTek's CA, press the
Connection button. When a successful connection has been established, the EC2000 will display a
message on the
Device Authorize/Deauthorize
is successfully tested."
7) If you want to manually re-authorize the EC2000, press the
When the re-authorization process has completed, the EC2000 will display a message on the
Authorize/Deauthorize
8.3

Client Certificate Option

The EC2000 can be configured for point-to-point authentication by refusing transactions from any card
issuance workstation that does not have a certificate installed.
To configure the client certificate options, follow these steps:
1) From the EC2000 touchscreen, navigate to
Authorize / Deauthorize
2) Under the
Client Certificate Options
3) Press the button to acknowledge that setup passwords are required, and to open the
OK
Certificate Options
4) Enter the first service password and press the
5) Enter the second service password and press the
Authorize / Deauthorize
6) Select the option you wish to use, then press the
a) The option directs the EC2000 to accept transactions from senders that present or do not
Ignore
present certificates for the https transaction.
b) The option directs the EC2000 to reject transactions from senders that do not present a
Require
client certificate. For senders that present a valid client certificate, the device will negotiate an
SSL connection with the sender, which will provide authentication, message integrity validation,
and message encryption.
8.4

Passwords

8.4.1 About Passwords

When the EC2000 is shipped, all passwords are set to factory defaults, which can be used to change all
passwords to customer-selected values (see section 6.6 About Passwords and Asterisks for more
information). To obtain default passwords to perform setup, call MagTek Support Services.
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 65
Main Menu
to open the Settings Menu
button to open the
page stating "The device is successfully authorized."
page.
label, press the
first password page.
page with a new
Status page, press the
page.
page.
Device Authorize/Deauthorize
Test Authorize/Deauthorize
page stating "The authorize/deauthorize connection
Request To Authorize Device
> >
Menu Settings Authorization
...
button.
button.
E
E button. The touchscreen will return to the
Client Certificate Options
button:
Apply
Status button.
page.
to open the
Client
box at the bottom.
button.
Device
Device