Magtek ExpressCard 2000 User's Installation And Operation Manual page 26

5 - Installation
b) Configure the EC2000's TCP/IP settings to work correctly on your network (see section 3.2
Network Planning and section 8.1 Network (TCP/IP) for details).
c) Authorize the device (see section 8.2 Authorizing the Device for details).
9) Open the EC2000's top access door (see section 6.5 Top Access Door Security for details).
10) Load card stock into the EC2000's card stock hoppers (see section 6.7 Card Stock for details).
11) If necessary, install an image printer ribbon and calibrate the image printer (see section 6.8 Image
Printer for details).
12) If necessary, install a tipper foil roll (see section 6.9 Foil Tipper for details).
13) If necessary, install an indent ribbon cartridge (see section 6.10 Indent Printer for details).
14) Test the device by creating sample cards (see section 6.11.1 How to Create Sample Cards).
15) Determine how the device's software will be configured:
a) Change all device passwords from defaults (see section 6.6 About Passwords and Asterisks,
and section 8.4.2 How to Change / Reset Passwords for details.).
b) If the configuration plan includes it, enable the touchscreen unlock feature (see 6.5 Top Access
Door Security for details).
16) If necessary, align printed images with embossed characters. See section 7.4 Re-Aligning Embossed
and Printed Characters for details.
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 26