PoolCop Installer And User Manual page 62

P a g e | 6 2
4.4.4.4 Understanding Pump Modes
On the PoolCop main display, next to Pump you will see the
mode in which the pump and filtration are running, or OFF.
The mode that has started and/or is now causing the pump to
be on will be displayed. In this example, the pump is filtering in
AUTO (see below) and a pressure of 0.98 Bar is displayed.
Valve
Mode What's happening now?
Positions
The filtration pump is OFF. No filtration
STOP All
cycles are defined.
The pump was started by the user, or by
the external run pump command, and is
running outside a programmed timer
MAN All period
Or
Pump is running inside a filtration cycle
but valve is not in filter position.
Filtration was started by or has now
entered a Filtration Timer cycle using
TIMER Filter
user programmed timer settings in Cycle
1 and/or Cycle 2 in TIMER mode.
Filtration was started by or has now
entered the Filtration Timer cycle and is
AUTO Filter
in an automatic mode (either ECO+ or
VOLUME).
Filtration is in Mode Forced, which was
FORCE Filter selected
Operations.
PoolCop is detecting a freezing risk and
is running the filtration to use warmer
FRZ Filter
water from the pool to reduce the risk of
the pool or equipment freeing.
Filtration
because a filtration cycle ends or a
PAUSE All
manual command or an event stopped
the pump.
Filtration has been started because of an
external request. (An input is configured
EXT Filter
to fulfil this behaviour) or Very High level
has been detected in the pool.
www.poolcop.com
I always take care of your pool in the most intelligent manner
possible, controlling the pump and filter to give you the greatest
Fundamental to understanding what is happening is for you to know
why the pump is running at this moment, and for that you simply
check which MODE is currently active.
by the user in
is momentarily stopped
Technical Support "Hotline" +33 (0)4 90 09 54 26
benefit possible.
1 2 : 4 6 : 0 1
Valve
Pump AUTO
Water Temp
AirTemp
Level
pH/ORP
M E N U
Water
What will happen next?
Treatment
The filtration will remain OFF as long as there is
OFF no filtration cycle or no manual command to
start the pump.
PoolCop will revert to the programmed filtration
OFF cycles (including repositioning the valve to Filter)
when the next timer starts.*
PoolCop will use fixed programmed timer
Active
settings to start and stop the filtration.*
PoolCop is optimising the filtration duration
Active based on measured temperature, as well as pool
and pump data settings.
Filtration will run for 23:00 per day for the
duration selected (24, 48 or 72 hours). PoolCop
Manual Active will then revert to the programmed filtration
cycles (including repositioning the valve to Filter)
when the next timer starts.*
30min after freezing risk has cleared, PoolCop
Active will revert to the programmed filtration cycles
when the next timer starts.*
Filtration will automatically restart with the next
OFF
filtration cycle.
Filtration will be running as long the external
OFF request is present, although it will respect the 2 x
1/2h pause per day.
P o o l C o p M a n u a l : V 3 1 E N
0 1 / 0 6 / 2 0 1 4
: Filter
: 0.98
: 28
: 32
: Normal
: 7.2/690
Bar
°C
°C
PCFR