General Information - PoolCop Installer And User Manual

P a g e | 3 6
3.5.4.6 Integrated Ionisation
3.5.4.6.1

General Information

Ionisation is an effective means of killing bacteria and algae, using copper or copper and silver charged particles. Ionisation has the
benefit of being very economical and allows treatment with low total chemical levels. Ionisation requires a remnant chemical for
oxidation. Consider using time daily control (3.5.4.1) for appropriate remnant chemicals.
The PoolCop has integrated ionisation functionality. The Ioniser Kit is required.
As a preventative measure, set Ioniser to OFF for new pools during the first 3 months of the pool's use. This
avoids any risk of an adverse reaction whilst the pool construction materials set and harden.
3.5.4.6.2 Installation
Verify that the pump circuit breaker is OFF, and/or set all pump timers in

Close all valves, except the waste valve (if fitted); ensure that all possible water supply is cut off.

In MANUAL CONTROL, select the valve to the

Ensure that the valve housing is depressurised and drained, by unscrewing the plug.

Removing the ioniser plugs from the housing or changing electrodes whilst there is pressure or a head of
water in the valve and piping can cause water to flood the Main Unit causing damage to the equipment.
www.poolcop.com
ORP measurement and control is not compatible with copper or copper/silver ionisation.
Carry out regular water analysis to ensure correct and safe dosing levels.
There is a risk of flooding if the pump timer were to switch the pump ON.
There is a risk of flooding if the water supply is not confirmed as cut off.
Technical Support "Hotline" +33 (0)4 90 09 54 26
NOTE:
CAUTION:
WARNING:
FILTRATION MODES
WARNING:
WARNING:
WASTE position
CAUTION:
P o o l C o p M a n u a l : V 3 1 E N
menu to 00:00/00:00.
PCFR