Diagnostics; Behavior In The Event Of An Error - WAGO 750-666/000-003 Manual

124

Diagnostics

9 Diagnostics
9.1

Behavior in the Event of an Error

The PROFIsafe I/O module detects internal and external errors. Internal errors are
detected by continuous self testing. Depending on the configuration, external
errors are detected and diagnosed by testing the external circuits to the extent
possible. When detecting an external error, a diagnostic message is output to the
safe PLC. The diagnostic messages for external errors are described in the section
"Diagnosis of Errors".
In the event of an error, all digital inputs and power outputs of the PROFIsafe I/O
module are passivated by outputting the substitute values (failsafe values) instead
of actual process values. For the digital inputs, the substitute values "0" for the
process image are transferred to the safe PLC. The digital power outputs are
switched off.
The external errors can be eliminated by maintenance personnel and must then be
acknowledged by the operator triggering an acknowledgement (operator
acknowledgement).
Both internal and external errors can be evoked by strong EMC events. If an
internal error is diagnosed, the PROFIsafe I/O module switches off for safety. In
this case, acknowledgement by the operator remains ineffective.
To check whether the cause of an internal error was a temporary EMC event and
thus caused the safety-oriented shutdown, switching the entire fieldbus node off
and then on again can be performed in an attempt to activate the PROFIsafe I/O
module again.
If shutdowns occur frequently due to internal errors, the PROFIsafe I/O module
should be replaced.
In this case, return the defective PROFIsafe I/O module to WAGO
Kontakttechnik GmbH & Co. KG for fault analysis.
750-666/000-003 4FDI/2FDO 24V/10A PROFIsafe V2 iPar
Version 1.2.0, valid from HW/SW Version 01/01
WAGO-I/O-SYSTEM 750
Manual