Table of Contents
Advertisement
12. From the
tion dialog box.
13. Select
14. From the
box. In the Project Settings dialog box, select the
15. In the Debugger page, select
16. In the Debugger page, select
menu.
17. Click
18. If you are prompted to rebuild any affected files, click
from the menu bar, then click
19. To run the application, select
changed, the following output will be presented in the HyperTerminal window:
Zilog Developer Studio
i = 5
d = 25
f = 1.260000
eZ80F91 5 25 1.260000
Viewing the Starter Project Output via the ZDS II Instruction Set
Simulator
The eZ80Acclaim! Cycle-Accurate Instruction Set Simulator interfaces with the ZDS II
Debugger to simulate the execution of programs without using an emulator or target hard-
ware. The Instruction Set Simulator uses the command set of the Debugger to perform
tasks such as simulating timers and interrupts.
To use the eZ80Acclaim! Instruction Set Simulator as an option, observe the following
steps to view the output of the
1. In ZDS II, open the
2. From the
box. Click the
3. In the Debugger dialog, select
clicking the checkbox next to the specific target name. Next, select
the
4. Click
5. If you are prompted to rebuild any affected files, click
from the menu bar, then click
UM024401-0412
Build
menu, select
Debug
, then click
OK
Project
menu in ZDS II, select
OK
to close the Project Settings dialog box.
starter.zdsproj
starter.zdsproj
Project
menu in ZDS II, choose
tab.
Debugger
Debug Tool
drop-down menu.
to close the Project Settings dialog box.
OK
eZ80AcclaimPlus! Development Kit
Set Active Configuration
to close the Select Configuration dialog box.
Settings
to open the Project Settings dialog
Debugger
eZ80F91ModDevKit_RAM
from the
USB Smart Cable
.
Rebuild All
Go
from the
Debug
menu. Until the default settings are
project in the ZDS II IDE.
project.
Settings
to open the Project Settings dialog
eZ80F91ModDevKit_RAM
Rebuild All
.
Running the Sample Starter Project
User Manual
to open the Select Configura-
page.
from the
Target
list.
drop-down
Debug Tool
. Otherwise, choose
Yes
from the Target pane by
Simulator
. Otherwise, choose
Yes
11
Build
from
Build
Advertisement
Table of Contents
