Windows Xp Systems; Installing The Ftdi Usb-To-Uart Driver - ZiLOG eZ80AcclaimPlus! User Manual

eZ80AcclaimPlus! Development Kit
User Manual
6

Windows XP Systems

Observe the following steps to install the USB Smart Cable on a Windows XP system.
1. Connect the USB Smart Cable to a USB port on the development PC. When the PC
2. In the Wizard, select
Note: If the Windows Hardware Installation dialog appears, click
3. In the Please choose your search and installations dialog, select
4. Use the
5. Click
6. Click

Installing the FTDI USB-to-UART Driver

An FTDI USB-to-UART driver is required to allow your PC to communicate through its
USB port to the on-chip UART of the eZ80AcclaimPlus! MCU. Observe the following
procedure to perform these connections.
1. Ensure that the USB cable is not plugged in to the eZ80AcclaimPlus! Development
2. Navigate to the following filepath and double-click the CDM20802_setup.exe file to
3. The installation process will begin and you should observe output similar to the fol-
4. When the installation is complete, plug in the Mini-B connector of the second USB
The eZ80AcclaimPlus! Development Kit
detects the new hardware, it will display the Found New Hardware Wizard dialog.
Install from a list or specific location (Advanced)
driver in these locations and include this location in search
Browse... button to navigate to one of the following paths:.
<ZDS II Installation Directory>\device drivers\USB\x32
<ZDS II Installation CD>\Device Drivers\USB\x32
to locate the appropriate driver.
Next
, then click
Next Finish
Board's P3 connector.
begin the driver installation.
<CDROM>\Device Drivers\FTDI Uart
lowing messages on the screen of your PC:
32-bit OS detected
<installation path>\dpinstx86.exe
Installation driver
FTDI CDM driver installation process completed...
cable into the Board, and the larger A connector into the USB port of your PC.
to complete the installation.
, and click
.
Continue Anyway
Search for the best
.
UM024401-0412
Next .