ZiLOG eZ80AcclaimPlus! User Manual page 20

eZ80AcclaimPlus! Development Kit
User Manual
10
Procedure
Observe the following steps to build and run the sample starter program for viewing in a
terminal emulation program on your PC, such as HyperTerminal.
Note:
While HyperTerminal is discussed in this document, it is not available on Windows 7 or
Vista machines. As an alternative, consider using Tera Term, which is available for down-
load from the Internet.
1. If you haven't already connected the UART-to-USB cable to the Board, return to the
2. Launch HyperTerminal. From the
3. In the
4. In the
5. In the
6. In the
7. Click
8. Launch ZDS II by navigating from the Windows
9. From the
10. Select the
11. Double-click the
The eZ80AcclaimPlus! Development Kit
Connecting the eZ80AcclaimPlus! Development Board to your PC
field, enter a name that describes the connection.
Name
box, select an appropriate icon for your connection, then click
Icon
Connect To dialog box, and from the
choose the COM port that is connected to the UART-to-USB port on the
eZ80AcclaimPlus! Development Board.
dialog box, set the following options:
Port Settings
– Bits per second: 57600
– Data bits: 8
– Parity: None
– Stop bits: 1
– Flow control: None
OK to establish a connection between HyperTerminal and the Board.
ZDS II – eZ80Acclaim! <Version>
File menu in ZDS II, choose
filepath:
c:\Program Files\Zilog\ZDSII_eZ80Acclaim!_<Version>\samples\
StarterProject
starter.zdsproj
source files will appear in the Workspace panel.
main.c
tor window. Refer to the header section of the
ect.
menu, click
File
Connect using:
Start
→
ZDS II – eZ80Acclaim! <Version>
Open Project
project within this filepath and click
file in the Workspace panel to open the file in ZDS II's Edi-
main.c
section on page 7.
.
New Connection
OK
drop-down menu,
→
menu to
Programs
.
, and navigate to the following
Open . A list of
file for details about the proj-
UM024401-0412
.
Zilog