Running A Sample Project - ZiLOG Z8 Encore! XP F64 Series User Manual

8. Use the I command to change the Z8 Encore! XP
9. Use the S command to change the Z8 Encore! XP
10. Use the G command to change the Z8 Encore! XP
11. Use the C command to verify the new settings.
12. Exit HyperTerminal.
13. Cycle the power on the Z8 Encore! XP
The hardware is now configured and ready for application development.

Running a Sample Project

After installing the ZDS II software and setting up the hardware, you can
run a sample software project to verify proper emulator operation and
experiment with the trace and event system. The sample project ice-
demo.pro is included in the ZDS II sample directory, located in:
Start ZDS II for the Z8 Encore! XP
instructions below to run
UM016804-0208
R Reset emulator
>
IP address to one that is compatible with the PC. Use caution to avoid
creating a conflicting IP address.
subnet mask to one that is compatible with the PC. Typically, the sub-
net mask is the same as that of the PC.
Gateway to one that is compatible with the PC. Typically, the gateway
is the same as that of the PC.
new settings to take effect.
c:\Program Files\ZiLOG\ZDSII_<product>_<version>
\samples\<processor type>_<demo name>
®
F64xx Series ICE for the
®
F64xx Series ICE and follow the
.
icedemo.pro
In-Circuit Emulator
User Manual
®
F64xx Series ICE
®
F64xx Series ICE
®
F64xx Series ICE
14