Table of Contents
Advertisement
For information about developing an application using the Z8FMC16100 Series of Motor
Control products, refer to the
(UM0130)
and/or the
(UM0151).
Installing ZDS II – Z8 Encore! Software
Observe the following steps to install the ZDS II Z8 Encore!
1. Insert the Zilog Developer Studio II CD into the CD-ROM drive. DemoShield launches
automatically. If DemoShield does not launch automatically, open the Windows Ex-
plorer, browse to your CD-ROM drive and double-click
staller.
2. Click the
Install Products
3. From the product installer list, you can choose to install ZDS II for both ZDS II and as-
sociated documentation. You can also copy the documentation directly from the CD-
ROM to your hard disk using Windows Explorer, or read the documentation directly
from the CD-ROM.
Installing the USB Smart Cable
The USB Smart Cable installation procedure differs based on the type of Windows operat-
ing system on which you will run ZDS II. This section describes how to install the USB
Smart Cable and associated driver software for your particular Windows OS.
32- and 64-Bit Windows 7
Observe the following steps to install the USB Smart Cable and associated driver software
for Windows 7 systems.
a. Connect the USB Smart Cable to the host PC. The
box is displayed.
b. Select
Locate and install driver software (recommended)
window is displayed; click
Control
window is displayed, followed by the
dialog box.
c. Select
I don't have the disc. Show me other options
d. Select
Browse my computer for driver software (advanced)
QS002810-0111
Z8FMC16100 Series Motor Control Development Kit
Zilog Developer Studio II – Z8 Encore! User Manual
Z8 Encore! XP F64XX Series Development Kit User Manual
button on the main installer menu.
®
software:
launch.exe
Found New Hardware
. The
Continue
Driver Software Installation
Found New Hardware–USB Smart Cable
.
Quick Start Guide
to launch the in-
dialog
. The
User Account
.
Page 4 of 12
Advertisement
Table of Contents
