Advertisement
2. Slide Power switch S2 to the ON position. The Green 3.3 V DC LED illuminates, indi-
cating that power is being supplied to the board. LEDs D2, D3 and D4 should blink in
sequence, indicating that your board is running the preloaded demonstration software.
As a result, your board is functional and ready for prototyping.
Installing the ZDS II – Z8 Encore! Software
Observe the following steps to install the software tools.
1. Insert the ZDS II CD into your computer's CD-ROM drive. DemoShield launches au-
tomatically. If DemoShield does not launch automatically, open Windows Explorer,
browse to your CD-ROM drive, and double-click the
installer.
2. DemoShield provides several installation options. Select
dio
to install now. You can install other software and accompanying documentation
later.
3. Follow the on-screen instructions to complete the installation.
Getting Started Using ZDS II
Observe the following steps to open and use the
Note:
These procedures reference the
c:\Program Files\Zilog\ZDSII_Z8Encore_<version_number>\
Samples\Z8xxxx_ledBlink\src
ZDS II version number and
For ZDS II v4.10.1 or lower:
c:\Program Files\ZiLOG\ZDSII_Z8Encore_4.10.1\samples\
Z8F04XP_8Pin_ledBlink\src
For ZDS II v4.11.0 and later:
c:\Program Files\ZiLOG\ZDSII_Z8Encore_4.11.0\samples\
XP_F082A\XP_F042A_8Pin_ledBlink\src
QS005506-0111
Z8 Encore! XP F042A 8-Pin Development Kit
launch.exe
Install Zilog Developer Stu-
ledBlink.zdsproj
ledBlink.zdsproj
, where
<version_number>
is the CPU family. For example:
Z8xxxx
Quick Start Guide
file to launch the
sample project.
file located in
is the
Page 8 of 15
Advertisement
